Free shipping on purchases over 300€ 
Free shipping on purchases over 300€
Gas hose per meter
Internal diameter 5mm
External diameter 10,5mm
Max 10 BAR
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
1/4 gas, right thread.
For gas regulator of rechargeable bottle.
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
3/8 gas, right thread.
For gas regulator of rechargeable bottle.
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
To be used with CO2 female regulator in order to connect the bottles with female connection.
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
Gas rapid connexion
For gas hoses 6-8 mm
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
Gas adapter 2m + adapter and 2 rings.
Gas hose for rechageable bottle
Diameter inside: 6 mm
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
Quick gas connection for Telwin welding machines:
Maxima 160 - 200
Technomig 180 - 210 - 215 - 225 - 240 wave - 260
Technology tig 222 ac-dc
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
CO2 cylinder adapter for gas regulator with Argon male connection
Female thread W21,8 / female thread W24,51.
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
Suitable to connect a gas regulator for rechargeable bottle on a throwaway bottle with M10 connection.
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
0 - 30 L/min
Argon or mix Argon CO2
Connection 1/4 gas
Pg6.5/9.8mm
Fast delivery (3-5 days) with DHL Courier in
Estonia
Choose your country
The welding process is not an exact science because the operator’s skill plays a part in the welding seam’s creation; this variable has a considerable impact on the final result.
The most common welding processes are in fact called manual (MMA-TIG) or semi-manual (MIG-MAG), and in both cases the ability to correctly set-up the generator is just as essential as the welder’s manual skill, especially when the welding seam is to be put under a lot of strain.
Assessing the quality of a weld is complicated for a non-trained eye, even when it looks good at first glance. On the other hand, even a less-than-trained eye can distinguish if the weld was produced with or without the use of a protection gas.
The welding processes that make use of a gas protection are aesthetically better because the welding arc is more stable and accurate and thus more manageable (few welding ledges). Even mechanically speaking (penetration and depth), the welding processes carried out with the use of a protection gas are of higher quality.
To equip a welding machine with a gas bottle it is necessary to acquire a gas hose and mounting clamps, any gas bottle fitting, a pressure reducer and an argon bottle adapter.
The gas bottle fittings vary based on the bottle and its gas; thanks to the gas bottle adapter, we will be able to use the same pressure reducer on different types of bottles and gasses.
In detail:
You will be able to adjust the amount of dispensed gas from the handle, and then view it on the manometer. You can then connect the generator thanks to the welding gas hose.
It is important to remember that the gas bottle connectors do not need any seal or insulation (such as Teflon, silicon, spray, etc.) and that you only need to connect them.
Italy
Austria
Belgium
Luxembourg
Netherlands
Monaco
Croatia
Denmark
Finland
Greece
Ireland
Portugal
Sweden
Bulgaria
Latvia
Lithuania
Poland
Czech Republic
Romania
Slovakia
Slovenia
Hungary
Germany
Spain
France
